I have gone as far as I can now until I trial fit - and after I purchase the engine loom. First, I got everything setup again:
Measured up the centre of the back panel and matched it up with the trim panel:
I started riveting from the centre, outwards. Next it was time to trim the corners where the tadpole trim wraps round, this time I took longer and made sure that I left enough material to "nip" under the corners. As I am no longer gluing it in place, it needs to be held in place by enough material:
Then it was just a case of taking my time, working centre outwards -note the temporary bolts, they help keep everything lined up:
And the end result, like I say I can only go so far because it will require a little fettling to get everything lined up on the car. At least now the fiddly bit has been done (hopefully!) and once I get the wiring loom purchased I can go ahead an trial, then permanent fit.
No comments:
Post a Comment