Rear Arch Trim

Not much done today, finished the rear boot infill - no pics as, it looks the same as the last one only fixed.

I've also done the passenger side trim above the wheel arch using tadpole trim.  It looks absolutely fine from the front and from the rear, but if you look closely there's maybe a 2mm gap between the panel and trim.  Like I say, not noticeable but I know its there.  I think I've just realised that the car isn't going to be perfect, no doubt other bits are going to come up along the way.

The problem is when I drilled the holes to attach the trim to the chassis I measured the width and drilled perfectly centre to the chassis, rather than lining up the outside edge and drilling from there.  It made sense at the time but frustratingly it should be a couple of mm to the left but I have no choice now but to go with it:

 

The inside looks fine and this will be covered by carpet anyway:

If I get chance tomorrow night I'll try get the drivers side done, run the inside trim around the rear top lip and then I think I'll start on the scuttle.

I'll conveniently miss the part out where I drilled through the end of my finger with a 3.2mm bit and ended up super gluing it together....